This past weekend we updated all our laptops to CRE 3.0, all went well til we got to the last two laptops. We installed CReo 3.0 same as before on a laptop that was running Creo 2.0M120 , when we clicked the Creo 3.0 icon the time dial ran for a few seconds then nothing happened , tried again same thing , no error codes etc... , we thought 2.0 may have been interferring , we deleted all the PTC files and started over from scratch , Firewall and Antivirus were off.
Same issue we click the Creo 3.0 ICon and get a time dial for about 5 seconds then it stays on the desktop screen , no errors, no codes as to what happened , it just won't run, any suggestions would be greatly appreciated , all other parts of install appear to go fine , IE getting a license, loading files, etc. no errors popped up. We did try reloading a third time with same results.